10318協和式飛機燈光安裝教程

10318 Concorde light installation tutorial

燈光材料如下

拿出燈光，將第一節燈條安裝如下

Lighting materials are as follows

Take out the light and install the first light strip as follows

將紅圈內的積木拆起

拿出配件把單獨的一節導線的燈粒安裝如下

Remove the blocks in the red circle

Take out the fittings and install the lamp particles of the separate

wire as follows

并將拆起的積木安裝還原

拿出箭頭所指的導線【2顆燈粒】

And remove the building blocks installed and restored

Take out the lead pointed by the arrow [2 light particles]

穿到飛機尾部如圖

拿出配件，將燈粒放配件內安裝如下

To the tail of the plane

Take out the accessory, put the lamp particle into the accessory

and install as follows

將剩下的燈光導線延箭頭方向穿過

將接下來的一節燈條安裝如下

Run the remaining light wires through the arrow

Install the next light strip as follows

相同方式將側邊積木拆起

Remove the side blocks in the same way

拿出配件，把單獨一節導線的燈粒安裝如下

拿出箭頭所指的導線【兩顆燈?！?/p>

Take out the fittings and install the lamp particles of a separate

wire as follows

Take out the lead pointed by the arrow [two light grains]

把導線拉到飛機后部

拿出配件將燈粒放配件內安裝如下

Pull the wire to the back of the plane

Take out the fittings and put the lamp granules into the fittings

for installation as follows

拿出最后一節導線

將如圖的積木拆起

Take out the last piece of wire

Remove the blocks shown in the picture

飛機頭部的位置也拆起

The nose of the plane was also removed

拿最后一節燈條安裝如下

Take the last light strip and install it as follows

把多余導線如圖拉到積木位置固定在積木內

Pull the excess wire to the block position as shown and fix it in

the block

積木安裝還原

Building block installation and restoration

最后將燈光插頭連接如下

Finally connect the light plug as follows

電池充電

battery charge